cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
837
Views
0
Helpful
4
Replies

Embedded Packet Capture problem on 2911 serial sub-interface.

kirilllissitsyn
Beginner
Beginner

  Hi all!

I'm unable to monitor any packets with EPC on Serial interfaces but Ethernet interfaces working just fine. I need exactly WAN monitoring on Serial sub-interfaces (Serial0/0/0:15, Serial0/0/1:15 etc.) because they are connected to our upstream VoIP provider (related to other VoiP problem).

 Is this a software bug or am i missing something? 

 Thanks!

 

C2900 Software (C2900-UNIVERSALK9_NPE-M), Version 15.7(3)M5

Cisco CISCO2911R-V/K9 (revision 1.0)

 

2911-3#show monitor capture point all
Status Information for Capture Point CP
IPv4 CEF
Switch Path: IPv4 CEF , Capture Buffer: BUF
Status : Active

Configuration:
monitor capture point ip cef CP Serial0/0/0:15 both

2911-3#show monitor capture buffer BUF para
Capture buffer BUF (linear buffer)
Buffer Size : 15360000 bytes, Max Element Size : 68 bytes, Packets : 0
Allow-nth-pak : 0, Duration : 0 (seconds), Max packets : 0, pps : 0
Associated Capture Points:
Name : CP, Status : Active
Configuration:
monitor capture buffer BUF size 15000 linear
monitor capture point associate CP BUF
2911-3#

4 Replies 4

pieterh
Engager
Engager

did you issue the start the capture command? : monitor capture point start CP

Of course. If i didn't then the Status would be Inactive

kirilllissitsyn
Beginner
Beginner

The "FUN" thing, that SPAN doesn't recognize Serial interfaces as Source so it's unavailable. 

 

2911-3(config)#mon session 1 source interface ?
GigabitEthernet GigabitEthernet IEEE 802.3z
Port-channel Ethernet Channel of interfaces

2911-3(config)#


RITE also doesn't work on Serial interfaces. Configuration accepted but 0 packets goes from Se0/0/0:15 to Gi0/2.

 

So sad

Giuseppe Larosa
Hall of Fame Master Hall of Fame Master
Hall of Fame Master

Hello @kirilllissitsyn ,

if you have ISDN PRI E1 with the provider you can use debug commands to see activity on D channel :15

 

debug isdn q921         ! L2 ISDN

debug isdn q931         ! L3 ISDN

 

Hope to help

Giuseppe

 

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers