enable password when configure aaa new model
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-07-2021 10:56 AM
hello all,
I have a cisco switch and I need to connect authentication by windows radius server 2019, I configure the server and try to enable aaa in the switch.
I type aaa new-model
radius server .....
only this commend after reconnect to switch I see enable mode in the switch, I don't have any enable or password for this !!! how can I remove this restriction from radius server 2019 or another way ?
thank you
- Labels:
-
Catalyst 2000
-
Catalyst 3000
-
LAN Switching
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-07-2021 12:10 PM
Hi
Have a look at this link:
https://www.reddit.com/r/Cisco/comments/3w2pvy/radius_authentication_with_enable_password_cisco/
HTH
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-07-2021 10:45 PM
hello Reza,
from the document, the enable password is known! but in my case, I don't know and don't configure the enable password.
the enable was created enabled by default when I enable aaa new-model
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-08-2021 08:57 AM
Hi,
If you don't have the password, then you may have to do a password recovery to reset the password.
HTH
