09-07-2021 10:56 AM
hello all,
I have a cisco switch and I need to connect authentication by windows radius server 2019, I configure the server and try to enable aaa in the switch.
I type aaa new-model
radius server .....
only this commend after reconnect to switch I see enable mode in the switch, I don't have any enable or password for this !!! how can I remove this restriction from radius server 2019 or another way ?
thank you
09-07-2021 12:10 PM
Hi
Have a look at this link:
https://www.reddit.com/r/Cisco/comments/3w2pvy/radius_authentication_with_enable_password_cisco/
HTH
09-07-2021 10:45 PM
hello Reza,
from the document, the enable password is known! but in my case, I don't know and don't configure the enable password.
the enable was created enabled by default when I enable aaa new-model
09-08-2021 08:57 AM
Hi,
If you don't have the password, then you may have to do a password recovery to reset the password.
HTH
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: