Can anyone advise on the queueing behaviour on a 6807 Sup6T
This is the current output from sh interface queueing
My understanding is that currently gi1/5/45 is trusting DSCP (Default Behaviour) but there is no queueing?
6807_Core1#sh queueing interface gi 1/5/45
Interface GigabitEthernet1/5/45 queueing strategy: Weighted Round-Robin
Port QoS is disabled globally
Queueing on Gi1/5/45: Tx Disabled Rx Disabled
Trust boundary disabled
Trust state: trust DSCP
Trust state in queueing: trust COS
Extend trust state: not trusted [COS = 0]
Default COS is 0
Queueing Mode In Tx direction: mode-cos
Transmit queues [type = 1p3q8t]:
Queue Id Scheduling Num of thresholds
I am transitioning from a 6509 where this was configured on the equivalent port.
wrr-queue bandwidth 5 25 20 20 20 5 5
wrr-queue queue-limit 5 25 10 10 10 5 5
wrr-queue random-detect min-threshold 1 70 100 100 100 100 100 100 100
wrr-queue random-detect min-threshold 2 70 100 100 100 100 100 100 100
wrr-queue random-detect min-threshold 3 70 100 100 100 100 100 100 100
wrr-queue random-detect min-threshold 4 70 100 100 100 100 100 100 100
wrr-queue random-detect min-threshold 5 70 100 100 100 100 100 100 100
wrr-queue random-detect min-threshold 6 70 100 100 100 100 100 100 100
wrr-queue random-detect min-threshold 7 70 100 100 100 100 100 100 100
wrr-queue random-detect max-threshold 1 100 100 100 100 100 100 100 100
wrr-queue random-detect max-threshold 2 100 100 100 100 100 100 100 100
wrr-queue random-detect 4
wrr-queue random-detect 5
wrr-queue random-detect 6
wrr-queue random-detect 7
wrr-queue cos-map 1 1 1
wrr-queue cos-map 2 1 0
wrr-queue cos-map 3 1 4
wrr-queue cos-map 4 1 2
wrr-queue cos-map 5 1 3
wrr-queue cos-map 6 1 6
wrr-queue cos-map 7 1 7
mls qos trust dscp
Any advice on the transition or a pointer to documentation would help as I am confused on the crossover between 6509 to 6807
Thanks
