hi all
iam looking to access my switch (3750g series VER: 12.2(35) SES) through ssh service . but couldnt as when iam looking to generate a RSA key pair it prompted like UNRECOGNISED COMMAND.
i went through the cisco articles and found that all 3750g series switch supports ssh service.
these all the commands i tried out , but everything vein, my company asking me to access switch through ssh. how should i do it now?
wavel3#conf t
Enter configuration commands, one per line. End with CNTL/Z.
wavel3(config)#
wavel3(config)#
wavel3(config)#cry?
% Unrecognized command
wavel3(config)#crypto ?
% Unrecognized command
wavel3(config)#host ?
WORD This system's network name
wavel3(config)#hostnam
wavel3(config)#hostname wavel3
wavel3(config)#cry
wavel3(config)#cry
wavel3(config)#cry?
% Unrecognized command
wavel3(config)#cry
wavel3(config)#ip ssh?
% Unrecognized command
wavel3(config)#ip ssh ?
% Unrecognized command
wavel3(config)#crypto ?
% Unrecognized command
wavel3(config)#crypto key generate rsa
^
% Invalid input detected at '^' marker.
wavel3(config)#line vty 0 4
wavel3(config-line)#transp
wavel3(config-line)#transport input ?
all All protocols
none No protocols
telnet TCP/IP Telnet protocol
how to enable ssh to my switch
are there any thoughts.
thanks in advance
srikanth
