Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
Bookmark
|
Subscribe
|
1742
Views
10
Helpful
6
Replies

Err disable commands are not working for my catalyst 2960 switch.

Go to solution
Invader12
Level 1
Level 1

‎12-27-2021 08:34 AM

iOS release version is 12.2(25)Fx. Kindly provide a fix.Screenshot (505).png

Labels:
0 Helpful
1 Accepted Solution

Accepted Solutions

Go to solution
paul driver
VIP
VIP
In response to Invader12

‎12-28-2021 12:22 AM

Hello

This is from Packet tracer not from real hardware correct?- if so i would this is down to the  PT software, it doesnt support a lot of features the real hardware would be able to.


Please rate and mark as an accepted solution if you have found any of the information provided useful.
This then could assist others on these forums to find a valuable answer and broadens the community’s global network.

Kind Regards
Paul

View solution in original post

6 Replies 6

Go to solution
marce1000
Hall of Fame
Hall of Fame

‎12-27-2021 09:26 AM

 

 - Could you give an example of what you tried and the outcome ?

 M.



-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
    When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '
0 Helpful

Go to solution
Invader12
Level 1
Level 1
In response to marce1000

‎12-27-2021 08:02 PM - edited ‎12-27-2021 08:07 PM

I tried errdisable commands to fix one of  the switch ports but the none of the commands are working. I am doing it in cisco packet tracer.

Screenshot (506).png

 

0 Helpful

Go to solution
paul driver
VIP
VIP

‎12-27-2021 09:29 AM - edited ‎12-27-2021 03:51 PM

Hello
show errdisable recovery
show sdm prefer


Please rate and mark as an accepted solution if you have found any of the information provided useful.
This then could assist others on these forums to find a valuable answer and broadens the community’s global network.

Kind Regards
Paul
0 Helpful

Go to solution
Invader12
Level 1
Level 1
In response to paul driver

‎12-27-2021 08:04 PM

Hi Paul, thanks for the reply. Below are the command results.

 

Screenshot (506).pngScreenshot (507).png

0 Helpful

Go to solution
paul driver
VIP
VIP
In response to Invader12

‎12-28-2021 12:22 AM

Hello

This is from Packet tracer not from real hardware correct?- if so i would this is down to the  PT software, it doesnt support a lot of features the real hardware would be able to.


Please rate and mark as an accepted solution if you have found any of the information provided useful.
This then could assist others on these forums to find a valuable answer and broadens the community’s global network.

Kind Regards
Paul

Go to solution
Leo Laohoo
Hall of Fame
Hall of Fame

‎12-27-2021 05:45 PM

12.2(25)FX?   Are you kidding me?  

That is the original IOS from the factory -- An INTERIM IOS version.  It is not meant to be used in production because it has extremely limited use.  Might work with the-most-basic Layer 2 function but that is where it stops.  

Fix is to upgrade the IOS version to something more recent.  

Top