Hey together,
I've got problems to activate ERSPAN on my Nexus N9K-C93108TC-FX
I want to analyse the PTP-Sync IEEE1588 between PTPClient-to-N9K with a additional Analyse-Client.
PTP-Client:
interface Ethernet1/29
ptp
ptp vlan 12
switchport access vlan 12
mtu 9014
Monitor:
Switch(config)# show monitor session 1
session 1
---------------
description : ptp_on_client
type : erspan-source
version : 3
state : down (No route to destination IP address)
erspan-id : 1
vrf-name : default
acl-name : acl-name not specified
ip-ttl : 255
ip-dscp : 0
header-type : 3
destination-ip : 192.168.99.1
origin-ip : 192.168.99.254 (global)
source intf :
rx : Eth1/29
tx : Eth1/29
both : Eth1/29
source VLANs :
rx :
tx :
both :
filter VLANs : filter not specified
source fwd drops :
marker-packet : disabled
packet interval : 100
packet sent : 0
packet failed : 0
egress-intf :
(try also with additional filter vlan 12)
Analyse-Client is connented to Interface eth1/34 with IP-Address: 192.168.99.1
version 7.0(3)I7(3)
interface Ethernet1/34
Switch(config)#
But i don't get any packet's with type "erspan" on Wireshark.
Does anyone know what is the Problem?
Why i get the State?
state : down (No route to destination IP address)
Thx,
Michael