Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
286
Views
0
Helpful
1
Replies

Ether channel configuration sync issue

HCL Support
Level 1
Level 1

‎08-03-2012 05:35 AM - edited ‎03-07-2019 08:08 AM

Hi,

We are facing the Ether Channel configuration sync issue as " Everytime when there is some issue with Etherchannel modules then we need to re-configure the Ether configuration again even if we either reset the problematic module or insert new module on same slot "

Common of all L3 switches is the module Part code: WS-X6748-GE-TX

Also attaching the show version, show module for these Switches. Suggest us if there is any bug impact with the current IOS running with these Switches or we have some Hardware issue with specific module part.

Regards,

Ashutosh         

Labels:
132741-S L3 switch.txt.zip
132742-P L3 switch.txt.zip
0 Helpful
1 Reply 1

Mandlenkosi Nkiwane
Level 3
Level 3

‎08-09-2012 02:22 PM

Could you provide the configuration of the etherchannels in question?

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card