04-03-2014 03:04 PM - edited 03-07-2019 06:59 PM
I just purchased 3 2960S-48FPD-L switches. I also ordered one (soon to be 2) 3850-24t-L. I am currently looking at purchasing an NM 4-1G module to go with the 3850. My intent in this is to configure etherchannels from the 3- 2960's front SFP ports, to the 4 port module I am getting for the 3850. I just want to make sure it is possible?
Thanks,
Wayne
04-03-2014 04:10 PM
yes it is possible.
regards
rc
04-03-2014 04:27 PM
Hi,
As long as the SFP you are going to use on both ends you should be fine, therefore just make sure of that.
Regards,
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide