02-27-2012 12:49 AM - edited 03-07-2019 05:12 AM
Hi
I have an etherchannel configured on a cat6k to connect to a netapp. the ints in the channel group are up but the port channel is down. when i do a show etherchannel summary it show that the ports are in portchannel 12A not 12. Any ideas
the config is attached.
02-27-2012 03:37 AM
Hi,
Looking at this link seems to infer that there is some difference between the 2 physical ports.
I do not see what is is.
May be show interface might point to the issue
A second prt channel xxA is created by lacp when discrepencies are found in the original xx channel group
Regards
Alex
02-27-2012 09:26 AM
In addition check the version of the netapp device - Last week I had similar issues with a netapp device. The solution was a software upgrade on the netapp-filer.
regards
Marcel
05-23-2012 11:58 AM
Can you paste an ifconfig -a output from the netapp controller here?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide