cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
934
Views
0
Helpful
3
Replies

Etherchannel issue with netapp

Tony MALPASS
Beginner
Beginner

Hi

I have an etherchannel configured on a cat6k to connect to a netapp. the ints in the channel group are up but the port channel is down. when i do a show etherchannel summary it show that the ports are in portchannel 12A not 12. Any ideas

the config is attached.

3 Replies 3

acampbell
Advocate
Advocate

Hi,

Looking at this link seems to infer that there is some difference between the 2 physical ports.

http://www.cisco.com/en/US/tech/tk389/tk213/technologies_configuration_example09186a0080094470.shtml#po1a

I do not see what is is.

May be show interface might point to the issue

A second prt channel xxA is created by lacp when discrepencies are found in the original xx channel group

Regards

Alex

Regards, Alex. Please rate useful posts.

Marcel Zehnder
Participant
Participant

In addition check the version of the netapp device - Last week I had similar issues with a netapp device. The solution was a software upgrade on the netapp-filer.

regards

Marcel

Devavrat Oka
Beginner
Beginner

Can you paste an ifconfig -a output from the netapp controller here?

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers