03-16-2018 01:56 AM - edited 03-08-2019 02:17 PM
hello, i need help for my problem. i am trying to configure LACP etherchannel between nexus 3048TP and catalyze the 2960s, the good news i have configured the LACP on 2960 s by following the procedure from cisco.com and success. But ... in nexus 3048TP by follow Cisco Nexus 3000 NX-OS Interfaces Configuration Guide, Release 5.0(3)U3(1), I can not set channel group and channel group mode if the interface is included in VLAN access, trunk mode, or switchport trunk allowed / native VLAN.
so i want to ask is it okay if i do not set interface in trunk mode, or switchport trunk is allowed / native VLAN? it will work fine?
interface information
try to config LACP but failed
regards
Nasir
Solved! Go to Solution.
03-25-2018 03:38 PM
thanks Eduard for your solution, i'm pleased to see your respond, but your instruction still doesn't work on my case. i'm greatfull for your explanation because it help me to analysis the prosedure to config my nexus 3048. so i have config etherchannel and success i do that without config guide, perhaps this procedure published in other subject on cisco guide but i can't find it.
To configure etherchannel on NX 3048tP.
03-20-2018 06:05 AM
Hi,
I think your errors appears because you are trying to modify one of the channel's port individually (int eth1/1) after you have make it a portchannel member, at that moment you need to modify the interface port-channel instead the individual ports. Can you try the configuration in this way:
configure terminal interface port-channel 3 interhace ethernet 1/1 switchport mode trunk channel-group 3 mode active interface port-channel 3 switchport trunk allowed vlan 18
03-25-2018 03:38 PM
thanks Eduard for your solution, i'm pleased to see your respond, but your instruction still doesn't work on my case. i'm greatfull for your explanation because it help me to analysis the prosedure to config my nexus 3048. so i have config etherchannel and success i do that without config guide, perhaps this procedure published in other subject on cisco guide but i can't find it.
To configure etherchannel on NX 3048tP.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide