Hello
Yes it can, once its removed it will also be removed for the physical interfaces relating to the port-channel.
It looks like this port-channel was configured first then either applied as a trunk or access port, .then changed again
Its not the correct way of creating a etherchannel, which would be setting up the physical interfaces first to whatever mode you wish them to be then add them to a port-channel - which will then be created automatically.
res
Paul
Please rate and mark as an accepted solution if you have found any of the information provided useful.
This then could assist others on these forums to find a valuable answer and broadens the community’s global network.
Kind Regards
Paul
