Etherchannel WLC & 4507

[anthony.dyne]

Hi

Seeking for Etherchannel configuration help between WLC 5508 and 4507.

thanks

Anthony

[Alexander Maroukian · Accepted solution]

Hi Anthony,

Follow this guide:

http://www.cisco.com/en/US/docs/wireless/controller/7.0MR1/configuration/guide/cg_ports_interfaces.html#wp1277659

I am giving you link because there are alot considerations when you are making the config and they are explained in this document e.g.  - When you enable LAG or make any changes to the LAG configuration, you must immediately reboot the controller

Best regards,

Alex

[Latchum Naidu · Accepted solution]

Hi Anthony,

Please see the example config on 4507 from best practice and currently I am using it.

interface Port-channel1
switchport
switchport trunk encapsulation dot1q
switchport trunk native vlan 50
switchport mode trunk

interface GigabitEthernet3/31
description Connected to Blade link 4
switchport trunk encapsulation dot1q
switchport trunk native vlan 50
switchport mode trunk
channel-group 1 mode on

Please rate the helpfull posts.
Regards,
Naidu.