Hello
I have a Cisco 2960x switch with the previous iOS
c2960x-universalk9-mz.152-4.E.bin
Was and got an upgrade to
c2960x-universalk9-mz.152-7.E3.bin
Via console cable
And that I deleted the previous iOS and commanded with the new iOS
show boot
show flash:
I checked and it was not a case
After reloading, I encountered a BOOT FAIL message
I want to go back to the factory settings but only the following items are shown in putty so I can not write a command
CPU rev: B
Image passed digital signature verification
Board rev: 5
Testing DataBus ...
Testing AddressBus ...
Testing Memory from 0x00000000 to 0x1fffffff ... | S
And it all happens again
Press & holding mode while powering up doesn't do anything.
And the switch lights are orange
I have a backup of the previous iOS on the tftp server