FAIL PORT - WS-X6148-GE-TX 48

[silviorodrigues]

Dears good morning!

I Have this Card With 48 Interfaces and an interface burned and the other sequence also stops working. Why this happend?

Thanks;

[Reza Sharifi · Accepted solution]

If the ports/module failed, then just RMA the modules to Cisco if you have SmartNet Contract

HTH

[silviorodrigues]

Reza, I Don´t!

For you to understand, the interfaces does not work from 1 to 8, but 9 to 48 is working.

Thanks!

[Reza Sharifi · Accepted solution]

Silvo,

If you don't have SmartNet, don't need ports 1 to 8 and don't have the funding to buy a new module then you can continue using what you have (ports 9 to 48)

HTH

[silviorodrigues]

Only one interface was fail, but always 1 to 8 it´s not work more.

So I just wanted endender so happened!

Thanks!

[Leo Laohoo]

Don't understand.

Can you post the output for the command "sh interface ", "sh interface status err" and "sh post" please?

[vmiller · Accepted solution]

sounds like the ASIC for ports 1 through 8 also has an issue that kicks in when port 1 fails.

[silviorodrigues]

Oh yes, thanks for your help!  Please do you have a link where explain about this?

Thanks!

[vmiller · Accepted solution]

http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/ios/12.2SX/release/notes/hardware.html#wp4815808

ports per group. groups are usually handled by 1 asic.