12-03-2019 08:17 PM
Hi
I have two Cisco 9500-40X-E switches with StackWise Virtual setup. They are running with Cisco IOS XE Fuji 16.9.3 image.
Can I upgrade the images to IOS XE Gibraltar 16.12.2 directly? I have found the following steps from the Cisco website, but I want to confirm whether it will work fine as I am going to update the firmware remotely in production environment. (These steps doesn't show copying the new firmware from tftp server to the switch)
###############################################################################################
Follow these instructions to perform In-Service Software Upgrade (ISSU) to Cisco IOS XE Gibraltar 16.12.1 with Cisco StackWise Virtual, in install mode.
Note that you can use this procedure for the following upgrade scenarios:
When upgrading from ...To...Cisco IOS XE Fuji 16.9.3 or Cisco IOS XE Fuji 16.9.4 | Cisco IOS XE Gibraltar 16.12.x |
The sample output in this section displays an upgrade from to Cisco IOS XE Gibraltar 16.12.1.
Step 1 | enable Enables privileged EXEC mode. Enter your password if prompted. Switch# enable |
Step 2 | install add file activate issue commit Use this command to automate the sequence of all the upgrade procedures, including downloading the images to both the switches, expanding the images into packages, and upgrading each switch as per the procedures. Switch# install add file tftp:cat9k_iosxe.16.12.01.SPA.bin activate issu commit |
Step 3 | show version Use this command to verify the version of the new image. The following sample output of the show version command displays the Cisco IOS XE Gibraltar 16.12.1 image on the device: Switch# show version Cisco IOS XE Software, Version 16.12.01 Cisco IOS Software [Gibraltar], Catalyst L3 Switch Software (CAT9K_IOSXE), Version 16.12.1, RELEASE SOFTWARE (fc1) Technical Support: http://www.cisco.com/techsupport Copyright (c) 1986-2019 by Cisco Systems, Inc. <output truncated> |
Step 4 | exit Exits privileged EXEC mode and returns to user EXEC mode. |
12-03-2019 08:33 PM
12-04-2019 11:25 AM
i have recently upgraded and documented
http://www.balajibandi.com/2019/10/11/cat-9500-stack-wise-virtual-configuration/
05-25-2022 07:43 AM
Hello Balaji the page is not available. Can you share?
Thank you
12-05-2019 01:50 PM
12-05-2019 02:19 PM
Agreed Hope original poster sure will read the release notes before upgrading the latest version and consider relevant steps according to the environment.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide