cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
549
Views
0
Helpful
1
Replies

[First time with Cisco] How to connect router with switch.

Don_Dude
Level 1
Level 1

Hello!

I am configure a WAN interface at now and also one of the lan interface for managment computer.

Now i am need to configure to send internet access router -> 48 port switch -> 15x 24 port switch -> 266 devices.

 

Already configured i thnik because it work:

Embedded-Service-Engine0/0 is administratively down, line protocol is down
  Hardware is Embedded Service Engine, address is 0000.0000.0000 (bia 0000.0000.0000)
  MTU 1500 bytes, BW 10000 Kbit/sec, DLY 1000 usec,
     reliability 255/255, txload 1/255, rxload 1/255
  Encapsulation ARPA, loopback not set
  Keepalive set (10 sec)
  ARP type: ARPA, ARP Timeout 04:00:00
  Last input never, output never, output hang never
  Last clearing of "show interface" counters never
  Input queue: 0/64/0/0 (size/max/drops/flushes); Total output drops: 0
  Queueing strategy: fifo
  Output queue: 0/40 (size/max)
  5 minute input rate 0 bits/sec, 0 packets/sec
  5 minute output rate 0 bits/sec, 0 packets/sec
     0 packets input, 0 bytes, 0 no buffer
     Received 0 broadcasts (0 IP multicasts)
     0 runts, 0 giants, 0 throttles
     0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
     0 input packets with dribble condition detected
     0 packets output, 0 bytes, 0 underruns
     0 output errors, 0 collisions, 0 interface resets
     0 unknown protocol drops
     0 babbles, 0 late collision, 0 deferred
     0 lost carrier, 0 no carrier
     0 output buffer failures, 0 output buffers swapped out

NVI0 is up, line protocol is up
  Hardware is NVI
  Internet address will be negotiated using IPCP
  MTU 1514 bytes, BW 56 Kbit/sec, DLY 5000 usec,
     reliability 255/255, txload 1/255, rxload 1/255
  Encapsulation UNKNOWN, loopback not set
  Keepalive set (10 sec)
  Last input never, output never, output hang never
  Last clearing of "show interface" counters never
  Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
  5 minute input rate 0 bits/sec, 0 packets/sec
  5 minute output rate 0 bits/sec, 0 packets/sec
     0 packets input, 0 bytes, 0 no buffer
     Received 0 broadcasts (0 IP multicasts)
     0 runts, 0 giants, 0 throttles
     0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
     0 packets output, 0 bytes, 0 underruns
     0 output errors, 0 collisions, 0 interface resets
     0 unknown protocol drops
     0 output buffer failures, 0 output buffers swapped out

GigabitEthernet0/0/0 is up, line protocol is up
  Hardware is EHWIC-1GE-SFP-CU, address is 707d.b9e9.91a8 (bia 707d.b9e9.91a8)
  Description: ISP
  Internet address is 203.91.x.x/30
  MTU 1500 bytes, BW 1000000 Kbit/sec, DLY 10 usec,
     reliability 255/255, txload 1/255, rxload 1/255
  Encapsulation ARPA, loopback not set
  Keepalive set (10 sec)
  Auto Duplex, Auto Speed, media type is LX
  output flow-control is XON, input flow-control is XON
  ARP type: ARPA, ARP Timeout 04:00:00
  Last input 00:00:16, output 00:00:09, output hang never
  Last clearing of "show interface" counters never
  Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
  Queueing strategy: fifo
  Output queue: 0/40 (size/max)
  5 minute input rate 4167000 bits/sec, 509 packets/sec
  5 minute output rate 3651000 bits/sec, 491 packets/sec
     1043451 packets input, 1141347190 bytes, 0 no buffer
     Received 1451 broadcasts (0 IP multicasts)
     0 runts, 0 giants, 0 throttles
     0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
     0 watchdog, 0 multicast, 0 pause input
     987750 packets output, 818498244 bytes, 0 underruns
     0 output errors, 0 collisions, 1 interface resets
     1158 unknown protocol drops
     0 babbles, 0 late collision, 0 deferred
     0 lost carrier, 0 no carrier, 0 pause output
     0 output buffer failures, 0 output buffers swapped out

GigabitEthernet0/1 is up, line protocol is up
  Hardware is CN Gigabit Ethernet, address is 707d.b9e9.91a1 (bia 707d.b9e9.91a1)
  Description: NabohuOPS
  Internet address is 192.168.5.1/24
  MTU 1500 bytes, BW 100000 Kbit/sec, DLY 100 usec,
     reliability 255/255, txload 10/255, rxload 9/255
  Encapsulation ARPA, loopback not set
  Keepalive set (10 sec)
  Full Duplex, 100Mbps, media type is RJ45
  output flow-control is unsupported, input flow-control is unsupported
  ARP type: ARPA, ARP Timeout 04:00:00
  Last input 00:00:07, output 00:00:06, output hang never
  Last clearing of "show interface" counters never
  Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 4293
  Queueing strategy: fifo
  Output queue: 0/40 (size/max)
  5 minute input rate 3657000 bits/sec, 491 packets/sec
  5 minute output rate 4134000 bits/sec, 506 packets/sec
     754665 packets input, 615303676 bytes, 4293 no buffer
     Received 90 broadcasts (0 IP multicasts)
     0 runts, 0 giants, 0 throttles
     0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
     0 watchdog, 0 multicast, 0 pause input
     752581 packets output, 809230232 bytes, 0 underruns
     0 output errors, 0 collisions, 1 interface resets
     0 unknown protocol drops
     0 babbles, 0 late collision, 0 deferred
     5 lost carrier, 0 no carrier, 0 pause output
     0 output buffer failures, 0 output buffers swapped out

 

 

Now i need to configure this interface for a this all switchs and devices:

GigabitEthernet0/0 is down, line protocol is down
  Hardware is CN Gigabit Ethernet, address is 707d.b9e9.91a0 (bia 707d.b9e9.91a0       )
  Description: $ETH-LAN$$ETH-SW-LAUNCH$$INTF-INFO-GE 0/0$
  Internet address is 10.10.10.1/25
  MTU 1500 bytes, BW 100000 Kbit/sec, DLY 100 usec,
     reliability 255/255, txload 1/255, rxload 1/255
  Encapsulation ARPA, loopback not set
  Keepalive set (10 sec)
  Auto Duplex, Auto Speed, media type is RJ45
  output flow-control is unsupported, input flow-control is unsupported
  ARP type: ARPA, ARP Timeout 04:00:00
  Last input 00:14:19, output 00:12:49, output hang never
  Last clearing of "show interface" counters never
  Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 1087
  Queueing strategy: fifo
  Output queue: 0/40 (size/max)
  5 minute input rate 0 bits/sec, 0 packets/sec
  5 minute output rate 0 bits/sec, 0 packets/sec
     231209 packets input, 205323567 bytes, 1087 no buffer
     Received 224 broadcasts (0 IP multicasts)
     0 runts, 0 giants, 0 throttles
     0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
     0 watchdog, 0 multicast, 0 pause input
     284499 packets output, 322094409 bytes, 0 underruns
     0 output errors, 0 collisions, 0 interface resets
     0 unknown protocol drops
     0 babbles, 0 late collision, 0 deferred
     7 lost carrier, 0 no carrier, 0 pause output
     0 output buffer failures, 0 output buffers swapped out

 

Of course i need help to choose good IP addressing / subnet masks for this LAN switch party network.

If any one help me with this configuration i will invite to Mongolia trip :)

 

By the way router is connected to switch with 1000base-T cable RJ45 and also this switch too support gigabitethernet port. Other switches only megabitethernet, devices too.

1 Accepted Solution

Accepted Solutions

Don_Dude
Level 1
Level 1
1 Reply 1

Don_Dude
Level 1
Level 1

Solved myself.