flexstack etherchannel

[e.ciollaro]

Hi,

I planning to stack two switches together with FlexStack and configuring a cross stack etherchannel; does this configuration require a special configuration or I have just to configure the ports as usual (I mean with channel-group ... mode ... command) ?

Thx,

enricol

[mmoulson1 · Accepted solution]

No configuration is require, just connect the stack cables and boot the switches. Once booted they are managed a one entity.

Have a look here:

http://www.cisco.com/c/en/us/products/collateral/switches/catalyst-2960-series-switches/white_paper_c11-578928.html

[Joseph W. Doherty · Accepted solution]

Disclaimer

The Author of this posting offers the information contained within this posting without consideration and with the reader's understanding that there's no implied or expressed suitability or fitness for any purpose. Information provided is for informational purposes only and should not be construed as rendering professional advice of any kind. Usage of this posting's information is solely at reader's own risk.

Liability Disclaimer

In no event shall Author be liable for any damages whatsoever (including, without limitation, damages for loss of use, data or profit) arising out of the use or inability to use the posting's information even if Author has been advised of the possibility of such damage.

Posting

For Etherchannel, no nothing special.  With the dual stack you'll just have another bank of ports to use.