cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1021
Views
5
Helpful
2
Replies

Fuji 16.9.x on 9300 - Flex connect APs

euucsupport
Level 1
Level 1

Hi all

Need some help around the port-security on 

 

Topology:

Wireless client > AP (flexconnect) > 9300 switch port > Core switch

 

My goal here is to enable port-security on the AP Native vlan.

I don't want to enable port-security on rest of the client vlans.

Port will be trunk port with AP vlan as native.

 

I have followed this url (as below), however it does not show how to enable port-security on just 1 vlan. Reason i say that, as i don't want wireless client affected or bound with the port-security, as wireless clients could be moving from one AP to another.

 

https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9500/software/release/16-9/configuration_guide/sec/b_169_sec_9500_cg/b_169_sec_9500_cg_chapter_0101001.html

 

I believe in the previous version i.e. 12.2, there was option to specify the (as below) to enabled port security on just specific vlans but can't find similar in the latest version.

Switch(config-if)# vlan-range range

https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst4500/12-2/25sg/configuration/guide/conf/port_sec.html#wp1061883

 

Thank you.

MK

1 Accepted Solution

Accepted Solutions

pieterh
VIP
VIP

you can configure port security for specified vlans (vlan-list):

   switchport port-security [maximum value [vlan {vlan-list | {access | voice}}]] 

View solution in original post

2 Replies 2

pieterh
VIP
VIP

you can configure port security for specified vlans (vlan-list):

   switchport port-security [maximum value [vlan {vlan-list | {access | voice}}]] 

Thank you.
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco