Getting error while upgrading 9300 stack switch in install mode
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-13-2023 09:09 PM
Any solution for below error?
#sh ver | i IOS
Cisco IOS XE Software, Version 16.09.04
Cisco IOS Software [Fuji], Catalyst L3 Switch Software (CAT9K_IOSXE), Version 16.9.4, RELEASE SOFTWARE (fc2)
Cisco IOS-XE software, Copyright (c) 2005-2019 by cisco Systems, Inc.
All rights reserved. Certain components of Cisco IOS-XE software are
documentation or "License Notice" file accompanying the IOS-XE software,
or the applicable URL provided on the flyer accompanying the IOS-XE
ROM: IOS-XE ROMMON
1 64 C9300-48U 16.9.4 CAT9K_IOSXE INSTALL
* 2 64 C9300-48U 16.9.4 CAT9K_IOSXE INSTALL
3 64 C9300-48U 16.9.4 CAT9K_IOSXE INSTALL
4 64 C9300-48U 16.9.4 CAT9K_IOSXE INSTALL
#dir flash: | i .bin
139266 -rw- 705009898 Feb 7 2020 16:33:12 +00:00 cat9k_iosxe.16.09.04.SPA.bin
139293 -rw- 1017587860 Feb 7 2023 16:37:45 +00:00 cat9k_iosxe.17.06.04.SPA.bin
#install add file flash:cat9k_iosxe.17.06.04.SPA.bin activate commit
% No connections to Shell Manager available for processing the command
- Labels:
-
LAN Switching
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-13-2023 09:57 PM
Please read the attached file. I have made the document easy-to-understand and I have thoroughly tested and applied the method for the last 5 years without a single failure.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-13-2023 10:09 PM
Hi Leo,
i have already refer your shared document but still facing the same issue... i am expecting solution on highlighted error below.
#$tform software package install switch all file flash:cat9k_iosxe.17.06.04.SPA.bin on-reboot new auto-copy verbose
% No connections to Shell Manager available for processing the command
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-13-2023 10:34 PM
@nileshshankarshete wrote:
% No connections to Shell Manager available for processing the command
No other option. Reboot the stack and re-run the Install Mode command.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-13-2023 10:41 PM
Yes, that's the only option...i have also seen same on cisco's bug solution.
