GVRP setting on a switch SG350xg and switch sg300

[lima91150]

Hello,

I want to distribute my vlans between an SG350xg switch and an sg300 switch.

I have read several procedures, watched several videos on youtube, such as https://www.youtube.com/watch?v=kUs8ToXApx8.

But, I did not manage to make an automatic creation of vlans on the secondary switch.

The sg350xg is the master switch on which I created vlans and the sg300 switch is the secondary switch on which I want to automatically create vlans via GVRP.

- The link port on each switch is in trunk mode and in the 1U vlan.
- GVRP mode is activated on each switch.
- GVRP state is also activated on the link ports as well as the creation and registration option.

I also restarted the two switches but the vlans are still not created on the secondary switch sg300

Do you have an idea, maybe I forgot something?

[balaji.bandi]

Make sure you have configured correctly please cross check with below config and post us the screen shot and network diagram how you connected each other switches (which was not working or populated VLAN)

https://community.cisco.com/t5/small-business-support-documents/configure-gvrp-settings-on-a-switch/ta-p/3172437

https://www.cisco.com/c/en/us/support/docs/smb/switches/cisco-small-business-300-series-managed-switches/smb5830-configure-gvrp-settings-on-a-switch-through-the-cli.html