Help on configuration of PBR on Cisco 3850 Switch

[VCsupport17]

Hello Community,

We have this network design:

Could you please help me how to configure PBR on our Cisco 3850 switch.

We have VLANs 10 and 20 and added a Guest Wifi network on VLAN 200. Also we have two ISP and two firewalls. Right now all traffic to internet is routed on ISP1 and works well.

We need to achieve the following:

- VLAN 10 and 20 traffic going to internet should utilize the ISP1.

- VLAN 200 traffic going to internet should utilize the ISP2.

Thank you in advance.

[Richard Burts]

I am not sure why the original post included the ip nat inside in its config. To answer your question: No you do not need ip nat inside. And in fact if you include it, it will not work. The 3850 switch does not support nat.