help setting up vpn tunnel and routing

[libliblib]

I've set up a VPN tunnel between a 7206 router, and a rv042 vpn router. The tunnel connects, but no traffic passes.

I'm assuming this is because I need to tweek NAT, ACL, routing, etc.

I'm testing this setup out right now, but here's how it would go.

Internet via ethernet into fasteth0/0 on dhcp(works, gets an IP)

Tunnel to rv042 via fasteth 2/0(tunnel connects)

Host on switch of RV042 needs to connect over VPN tunnel to be able to get online.

Is there any guides that would help me out?

[Ganesh Hariharan]

I've set up a VPN tunnel between a 7206 router, and a rv042 vpn router. The tunnel connects, but no traffic passes.
I'm assuming this is because I need to tweek NAT, ACL, routing, etc.
I'm testing this setup out right now, but here's how it would go.
Internet via ethernet into fasteth0/0 on dhcp(works, gets an IP)
Tunnel to rv042 via fasteth 2/0(tunnel connects)
Host on switch of RV042 needs to connect over VPN tunnel to be able to get online.
Is there any guides that would help me out?

Hi,

Check out the below link hope that help

http://www.cisco.com/en/US/tech/tk583/tk372/technologies_configuration_example09186a008009438e.shtml

Ganesh.H