I'm trying to setup l2tpv3 with the information on this page.http://www.networkworld.com/community/node/26272.When I assign an IP to both fasteth interfaces, I get this error when I assign xconnect to them. "Incompatible with ip address command on fa...

I've set up a VPN tunnel between a 7206 router, and a rv042 vpn router. The tunnel connects, but no traffic passes.I'm assuming this is because I need to tweek NAT, ACL, routing, etc.I'm testing this setup out right now, but here's how it would go.In...

I need to create a layer 2 tunnel with a router and a pix 501 and each end. But, if I use IPsec on a the pix501, the throughput is only 5 or so mpbs. Cleartext on a 501 is 60mbps. I can setup a psuedowire on the router, but I don't think the pix 501 ...