I have a new WAP200. When I plug
it in with its default setting it works (i can connect via unsecure
wireless to my network) so I know I have connectivity to the device.
The problem occurs when I try to attach to the device to configure it.
I can neither attached to the device or even ping it on it's factory
default setting of 192.168.1.254. I have done two device resets with no
Does anyone have any suggestions or how could I contact Cisco for an RMA request as I feel this product is defective.
If you feel that this device needs to replcaed and as there no luck after two reset, you would have purchased the samrnet contract with cisco just log cisco TAC case with contract id and rest will be done by cisco if it needs to replaced.
Hope to Help !!
Remember to rate the helpful post