cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
881
Views
0
Helpful
2
Replies
Texas Hare
Beginner

How can i configure the ssh on C4507 Switch?

Hello

I have been using the C4507R+E with WS-X45-SUP8-E supervisor.

I tried to configure the SSH for remote connect. but i couldn't complete that. it seems to be doesn't support any SSH command on this OS version.

cat4500es8-universal.SPA.03.07.02.E.152-3.E2.bin

ROM: 15.1(1r)SG5

How can i configure the ssh on this C4507 switch and OS version? i supposed upgrade to another OS?

Thanks

1 ACCEPTED SOLUTION

Accepted Solutions
Leo Laohoo
VIP Community Legend

cat4500es8-universal.SPA.03.07.02.E.152-3.E2.bin

The IOS does NOT support SSH.  The IOS that supports SSH should have the characters "k9" in the filename.  

ROM: 15.1(1r)SG5

Read the Release Notes carefully.  Under Upgrading the System Software it states:  

If you are upgrading to Cisco IOS XE 3.7.xE and using Supervisor Engine 7-E or 7L-E, you must use ROMMON version 15.0(1r)SG10 or a higher version (if available).

View solution in original post

2 REPLIES 2
Leo Laohoo
VIP Community Legend

cat4500es8-universal.SPA.03.07.02.E.152-3.E2.bin

The IOS does NOT support SSH.  The IOS that supports SSH should have the characters "k9" in the filename.  

ROM: 15.1(1r)SG5

Read the Release Notes carefully.  Under Upgrading the System Software it states:  

If you are upgrading to Cisco IOS XE 3.7.xE and using Supervisor Engine 7-E or 7L-E, you must use ROMMON version 15.0(1r)SG10 or a higher version (if available).

Thanks for reply.

I will prepare to OS upgrade.