Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
There are 5 of same IX5000 systems installed on the customer's site.Recently, We had completed successfully the upgrading OS work from 8.2.3(14) to 9.1.3(14).But one of five device was not able to complete the upgrading work.When restart the system, ...
We have been using conductor for making multiparty meeting room.And I'd created the template for password in order to establishing security.As a result, all participiants and devices will be able to type password when joining.But one site couldn't jo...
To upgrading software of Roomkit+ device, I had found the software on cisco homepage.But I Couldn't find the *.pkg file that can upgrading on device administrator page.There are only *.sgn files available. As far as i know, *.sgn file can only apply ...
I had installed the Roomkit+ yesterday. All cables connected correctly and I checked the device works properly.In order to complete installation procedure, I tried to connect to administation page through Internet Explorer11.But when I click the Logi...
Thanks for reply.
I understand this behaviour. but i have question more.
Backup_Switch#traceroute 192.168.23.241Type escape sequence to abort.Tracing the route to 192.168.23.241 1 192.168.99.5 12 msec 192.168.99.1 16 msec *
This is result of t...
Thankyou for reply. Here are "show module" part of log below - SG10#show moduleMod Ports Card Type Model Serial No.--- ----- -------------------------------------- ------------------ ----------- 1 0 2 po...
