06-24-2024 07:20 PM - edited 06-24-2024 07:34 PM
Thank you in advance for your assistance!
Solved! Go to Solution.
06-25-2024 12:00 AM
As u see u have SVI interfaces Vlan 64,65,100 with IP addresses and UP UP state (show ip interfaces brief); This puts those IPs as routes (networks) into routing table, aka RIB. - see show ip routing - as C (connected routes). L3 switches and routers can do routing on its own between directly connected networks (interfaces). In case of L3 switch, switch does routing between SVI interfaces (switched virtual interfaces). you assign devices to particular vlan and subnet ( IP plus mask id) and connect them to access ports. PCs belonging to vlan x can ping each others without any help inside that vlan x. PCs in vlan y need L3 device to reach PC in vlan x via SVI interfaces and switch RIB. You can connect another PC directly to switch w/o Hub or L2 switch. Note: it is not recommended to use Hubs any longer in real world; good learning practice .though.
Also, You can attach your PT file here but it must be in a zip format;
Also check CLN community PT and CCNA forums at https://learningnetwork.cisco.com/s/topic/0TO6e000000WEorGAG/packet-tracer
https://learningnetwork.cisco.com/s/topic/0TO3i0000008jYHGAY/ccna-certification-community
Regards, ML
**Please Rate All Helpful Responses **
06-24-2024 11:02 PM
- FYI : Community group for Packet Tracer project questions
M.
06-25-2024 12:00 AM
As u see u have SVI interfaces Vlan 64,65,100 with IP addresses and UP UP state (show ip interfaces brief); This puts those IPs as routes (networks) into routing table, aka RIB. - see show ip routing - as C (connected routes). L3 switches and routers can do routing on its own between directly connected networks (interfaces). In case of L3 switch, switch does routing between SVI interfaces (switched virtual interfaces). you assign devices to particular vlan and subnet ( IP plus mask id) and connect them to access ports. PCs belonging to vlan x can ping each others without any help inside that vlan x. PCs in vlan y need L3 device to reach PC in vlan x via SVI interfaces and switch RIB. You can connect another PC directly to switch w/o Hub or L2 switch. Note: it is not recommended to use Hubs any longer in real world; good learning practice .though.
Also, You can attach your PT file here but it must be in a zip format;
Also check CLN community PT and CCNA forums at https://learningnetwork.cisco.com/s/topic/0TO6e000000WEorGAG/packet-tracer
https://learningnetwork.cisco.com/s/topic/0TO3i0000008jYHGAY/ccna-certification-community
Regards, ML
**Please Rate All Helpful Responses **
06-25-2024 12:03 AM
also see my reply https://community.cisco.com/t5/routing/vlan-s-on-layer-3-switches/td-p/5132193
Regards, ML
**Please Rate All Helpful Responses **
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide