How do I recreate a port channel switch virtual link on a C9500-16?

[victoriabardy]

Hello all,

I am in the process of configuring a new hardware to replace our existing core Catalyst 4500 switches with Cisco 9500 switches.  I have two port channels with the following configuration:

interface Port-channel2
switchport
switchport mode trunk
switchport nonegotiate
switch virtual link 2

When I recreate the port channel on the new hardware I get an error when I try to add "(config-if)# switch virtual link 1
^
% Invalid input detected at '^' marker."

I did a few searches but not coming up with the proper cli command to create this SVL.  Can someone here on the forum assist with the proper command?  Please let me know.

Thank you.

Rgds,

Vicky

[marce1000 · Accepted solution]

  - Ref  : https://community.cisco.com/t5/networking-knowledge-base/stackwise-virtual-tips-and-tricks/ta-p/4922633
                          You may need stackwise-virtual link 2  instead on this platform ,

 M.