12-02-2009 08:13 AM - edited 03-06-2019 08:48 AM
spanning-treemode rapid-pvst
spanning-tree extend system-id
no spanning-tree vlan 200,210,220,230,240,250,300,310,320,330,340
spanning-tree vlan 1-2,100,110,120,130,140,150 priority 24576
spanning-tree vlan 200,210,220,230,240,250,300,310,320,330,340 priority 28672
diagnostic bootup level minimal
!
I don't want to have the second spanning-tree vlan line to show up at all. They were added but we are changing and will not even have those VLANs on this switch.
I did the "no" command but it just added another annoying line of code.
Any suggestions?
James
Solved! Go to Solution.
12-02-2009 08:49 AM
Try this in config mode:
no spanning-tree vlan 200,210,220,230,240,250,300,310,320,330,340 priority 28672
spanning-tree vlan 200,210,220,230,240,250,300,310,320,330,340
That should do it.
12-02-2009 08:36 AM
James,
If you are not able to remove all with one command, then try removing them one at the time
HTH
Reza
12-02-2009 08:49 AM
Try this in config mode:
no spanning-tree vlan 200,210,220,230,240,250,300,310,320,330,340 priority 28672
spanning-tree vlan 200,210,220,230,240,250,300,310,320,330,340
That should do it.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide