How to Change IP Address on my Cisco 2901 Integrated Services Router

[Mickeysuzy651]

I have a Cisco 2901 Integrated Services Router that has the default IP address of 192.168.0.1 but I am also running a 2nd router that has the same default IP address.  How do I change the IP address on my Cisco 2901 Integrated Services Router? 

[Richard Burts]

You need to follow these steps:

- access the router (via console, or telnet or SSH)

- login to the router

- go to enable mode

- enter config t

- go to interface config mode for the interface

- use the ip address command to change the address

- exit config mode

- save the running config to startup config

HTH

Rick

[Tom_Leo]

Rick,

How can I do the same on a Cisco RV260?

Thanks,

Tom

[Tom_Leo]

I figured it out.  Obviously, I'm a beginner.  It's all in the default VLAN. 

I am sure I will be back!  Lots of good reading here, I promise I see.

Tom