How to check if user got it´s IP assigned via DHCP or is using static

[uppermost]

On the 9300 switch, is there a way to tell whether users in specific VLAN have been assigned their IPs via dhcp relay or if they are using static IPs ?

[Flavio Miranda]

Hello,

   I dont think it is possible. If this 9300 is a access switch in Layer2 mode, you can see only the mac address.  In a layer3 device, you are able to see the ARP table but static and dynamic IP will be shown the same way.

[MHM Cisco World · Accepted solution]

You can run dhcp snooping and DAI' 

Any user can not access network meaning it use manaul IP address.