How to configure VSS with two different supervisor engine (3c & 3cXL) in 6500 series

[maniselvam77]

Dear all,

          I have configured the VSS in two cisco 6509-E series with only one supervisor engine, but if i configured with two supervisor engine. it is going to rommon mode. One supervisor engine is 3c and 3cxl. Please advice.

[Harish Balakrishnan · Accepted solution]

Hello Selvam,

Both the supervisor modules has to be same in order for them to operate in VSS mode

Please refer the below document

http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/ios/12.2SX/configuration/guide/vss.html#wp1053954

Regards

Harish

Please rate helpful posts!

[maniselvam77]

Hi Harish,

              I have one 65000 series with two VS-S720-10G-3C and another VS-S720-10G-3CXL, It will support or not, I have configure with one supervisor engine each. It is working fine. I have configured with VS-S720-10G-3CXL

Regards

Selvam