How to connect via SSH/Telnet from a Cisco SG220 Switch ?

[westfordplace1988]

Hello everyone, this is my first time posting a question on the Cisco community.

This could be really simple but i'm trying not to break my head against the wall...

I need to connect via SSH/Telnet from my SG220 to another SW on the network (which i know it responds to SSH/Telnet) but the thing is ... whenever i type 

SW01#ssh 192.168.1.1

% Unknown command

SW01# telnet 192.168.1.1

% Unknown command

I know this is VERY basic but this is the first time i see an error like this, i am not really used to work with SG220 SWs

Any ideas ?

Thank You!

[balaji.bandi · Accepted solution]

Not sure these device support, check on VTY Line below comand to send out.

transport output telnet ssh

[westfordplace1988]

Thank you so much for the quick reply.

I cannot use that command either...

Is this Cisco SW telling me... i cannot do SSH/Telnet from it? Seriously ??

[balaji.bandi]

can you post show run from command level