11-22-2006 07:39 PM - edited 03-05-2019 12:59 PM
Dear all,
How to monitor 2950 switch after reload ?
Pls advise
Stanley
11-22-2006 08:33 PM
At time of booting u can see output to console only so connect using console and see output
However, make sure the logging console level is set as desired and that logging has not been disabled with the no logging console command
And after booting u can use various debug command . to see output of debug command on vty use term monitor command in priviledge config mode
Regards
Mahesh
11-22-2006 08:36 PM
Dear Mahesh,
Thanks you your reply, but there have any quick commad to check the switch status?
Stanley
11-22-2006 08:42 PM
means
what exactly u want to know about switch
whether u want to know link up-down or anything else
and do u want it from console or from vty?
pl. reply
mahesh
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide