ā08-06-2013 06:41 AM - edited ā03-07-2019 02:46 PM
z-core#show interfaces status
Port Name Status Vlan Duplex Speed Type
Te0/1 R-CORE connected trunk full 10G
Te0/2 M-CORE notconnect 1 full 10G
As you can see Type feild is emty, so I'm unable to find out transeiver's type e.g. 10GBASE-LR, 10GBASE-ER and etc. How to look into it's eeprom data?
Solved! Go to Solution.
ā08-07-2013 04:21 PM
sh inventory
ā08-06-2013 03:46 PM
Command: sh idprom interface
ā08-07-2013 12:23 AM
Leo,
Thanks, there's no such command on ME3800:
z-core#show i?
idb identity idmgr if-mgr
interfaces inventory ip ipam
ipc ipv6 isis
z-core#show ver
Cisco IOS Software, ME380x Software (ME380x-UNIVERSALK9-M), Version 15.2(4)S, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2012 by Cisco Systems, Inc.
Compiled Fri 20-Jul-12 18:52 by prod_rel_team
ā08-07-2013 01:59 AM
Darn. I thought this command is supported.
How about "sh interface
ā08-07-2013 03:16 AM
z-core#sh interface TenGigabitEthernet 0/1 transceiver properties
Name : Te0/1
Administrative Speed: 10000
Administrative Duplex: full
Administrative Auto-MDIX: on
Administrative Power Inline: N/A
Operational Speed: 10000
Operational Duplex: full
Operational Auto-MDIX: on
Media Type:
z-core#sh interface TenGigabitEthernet 0/2 transceiver ?
detail Show interface transceiver detail
properties Show interface transceiver properties
| Output modifiers
The output shows something but not what we expected. Neither "detail" did (just DOM statistics)
ā08-07-2013 04:21 PM
sh inventory
ā08-07-2013 09:40 PM
z-core#show inventory | begin "TenGigabitEthernet0/1"
NAME: "TenGigabitEthernet0/1", DESCR: ""
PID: SFP-10G-LR , VID: V02 , SN: ECL150902DA
NAME: "TenGigabitEthernet0/2", DESCR: ""
PID: SFP-10G-LR , VID: V01 , SN: T12110975
ā08-07-2013 10:20 PM
LOL!
I should've used that first. I thought you wanted MORE information than that.
Thanks for the ratings.
ā08-08-2013 12:39 AM
You are welcome. In this particular case all I need to know is the transceiver's type which is preprogrammed into its eeprom. Probably ME3800 retrieves only basic info for 'sh inventory' and does not support to view all data.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide