cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Join Customer Connection to register!
1572
Views
0
Helpful
4
Replies
kaiven_chu
Beginner

How to remove module from running-config without reload switch?

Dears,

We just bought a new module  WS-X6816-10GE, and insert into Cat6509 slot 8 by test.

And now we move it back to slot 7, then show module, the new module appears on both slot 7 and 8.

Then I try to reload module, and show module again, It's come back to normal.

Mod Ports Card Type                              Model         

--- ----- -------------------------------------- ------------------

  1  24  CEF720 24 port 1000mb SFP              WS-X6824-SFP   

 

  3  48  CEF720 48 port 10/100/1000mb Ethernet  WS-X6848-GE-TX   

  5    5  Supervisor Engine 2T 10GE w/ CTS (Acti VS-SUP2T-10G     

7  16  CEF720 16 port 10GE                    WS-X6816-10GE     

But through show run commond, I still see the interface TenGigabitEthernet8/1 -16 in it.

And I tried to use "no interface te8/1" to remove the interface from running-config, but it doesn't work.

Is there any way for me to remove it from running-config without reboot switch?

1 ACCEPTED SOLUTION

Accepted Solutions
Jon Marshall
VIP Community Legend

What you should have done is use the module clear-config command before removing the module.  What you can try is to put the module back into slot 8 and then follow the instructions in this link -

http://www.cisco.com/en/US/products/hw/switches/ps708/products_configuration_example09186a008086ed2e.shtml#erase_config

Jon

View solution in original post

4 REPLIES 4
weijun.duan
Beginner

hi

hehe,First encounter,It does not affect your work on slot 7 .

Proposal ,wr-------copy start-configt  tftp------check it.
  try to :default int g8/1   。

Hi, Weijun

That config is stored in RAM, and everyting works fine.

If I backup it to tftp, and modify the config then copy it back to run, the running-config will be "merged" but not overwrited.

I afraid that I need to reboot the switch

Jon Marshall
VIP Community Legend

What you should have done is use the module clear-config command before removing the module.  What you can try is to put the module back into slot 8 and then follow the instructions in this link -

http://www.cisco.com/en/US/products/hw/switches/ps708/products_configuration_example09186a008086ed2e.shtml#erase_config

Jon

View solution in original post

Dear Jon.marshall,

OK, got it,

I'll try it, Thanks a lot.