How to replace a failed redundant supervisor 2 on Catalyst 6509 running native mode.

[andrea.meconi]

Hi.

I'm looking for a doc to replace a failed sup2 on 6509 running native mode.

Thanks.

[Reza Sharifi]

Hi,

Have a look at this doc.  There is a section for sup2 replacement.

http://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst6500/hardware/Module_Installation/Sup_Eng_Guide/supe_gd/03instal.html

HTH

[andrea.meconi]

Hi.

Many thanks for your help.

We have a chassis with two redundant supervisor 2 and one is now damaged.

Chassis is native and operates with RPR.

I'm looking for detailed procedure to replace the faulty supervisor.

I think I need to disable auto-sync, load the same IOS and finally enable the auto-sync again.

Is it right?