11-24-2006 08:56 AM - edited 03-05-2019 01:00 PM
Hi all,Can anyone tell me how to reset a pix 501 to factory defaults ?
11-24-2006 09:32 AM
Hi Carl,
Use "configure factory-default" command once you are in enable mode.
HTH,
-amit singh
11-27-2006 03:29 AM
What if I do not have the password for this device ? how do I reset then, is there a rommon mode ?
11-27-2006 04:01 AM
Yes, Carl there is a rommon mode called as monitor mode. Reboot the pix and press esccape key, you will fall in the monitor mode. But I am not sure that you can set the pix on factory-default while in monitor mode.
You can do a password recovery on PIX and then set it up on the factory-default if you want. Please check the link below for password recovery.
http://www.cisco.com/warp/public/110/34.shtml
HTH,Please rate if it does.
-amit singh
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide