How to set time in CISCO IE 4010

[grapevine]

How to set time in CISCO IE 4010

I dont see clock set command

SW01(config)#clock ?
calendar-valid Calendar time is authoritative
summer-time Configure summer (daylight savings) time
timezone Configure time zone

[marce1000]

  - Could you try the command anyway as in : Switch# clock set 13:32:00 23 July 2001   (e.g) -adapt accordinglt

  M.

[grapevine]

Tried, didnt work. I found this online: - 

The Cisco IE 4010 does not retain time when rebooted because it does not have a battery-powered real-time clock. Instead, it relies on NTP to get accurate time after booting.

For persistent time settings, always configure an NTP server rather than manually setting the time.

[liviu.gheorghe]

@grapevine You are trying to configure the clock command in the configuration mode which is wrong. 

As @marce1000 suggested, configure it from enable mode: 

Switch# clock set <time> <date>

HTH

[liviu.gheorghe]

You can also configure a ntp server for your device:

SW01(config)#ntp server <IP address or name of NTP server>