11-08-2015 09:04 PM - edited 03-08-2019 02:37 AM
Does below diagrm of HSRP work properly? Any special configuration necessary on L3 Switch?
11-09-2015 02:14 AM
That looks good , set pcs as vip ip address, make sure hsrp forms and drop 1 of the paired hsrp interfaces at a time and make sure pcs can still break out, only thing is think about using glbp if all cisco gear to make use of all links and switches and be able to load-balance
11-12-2015 11:33 PM
Thank you very much
11-09-2015 10:59 PM
Hello,
Diagram dont show interconnectivity between switches, Assuming that has been taken care either directly or via some layer 2 switch.
and the above logical diagram will fit for FHRP.
Hope it Helps..
-GI
11-12-2015 11:33 PM
Thank you very much.
11-13-2015 07:40 AM
Thank you very much.
Hello,
Glad you got problem solved, helpful if you can mark this thread has answered so that others can be benifitted.
-GI
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide