Buy or Renew
Buy or Renew
NOTICE: You can now engage in the community. Learn about the great new Cisco Umbrella content.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
5218
Views
0
Helpful
37
Replies

I can't ping my fa0/0 from my fa0/1 network..

Ngjohnquilla
Level 1
Level 1

‎12-29-2016 12:36 AM - edited ‎03-08-2019 08:44 AM

I have a cisco 2600 router and a 3550 switch

Conf of my switch

vlan 10(active and up)

 fa0/1 this is connected to my router fa0/0

 fa0/3 this is connected to my laptop A

Conf of my switch

vlan 20(active and up)

 fa0/5 connected to my router fa0/1

 fa0/9 connected to my  laptop B

**************************************

Conf of my router 2600

Fa0/0 ip address 10.1.10.1

Fa0/1 ip address 10.1.20.1

Ip route 0.0.0.0 0.0.0.0 fastethernet 0/1

My question is why cant i ping fa0/0  from fa0/1

My laptop B

ip address is 10.1.20.12

Gateway 10.1.20.1

My laptop A

Ip address is 10.1.10.12

Gateway 10.1.10.1

Labels:
0 Helpful
37 Replies 37

Georg Pauwen
VIP
VIP
In response to Ngjohnquilla

‎12-29-2016 08:55 AM

Hello,

in the GNS setup, I did not use any default route.

Try and remove:

Ip route 0.0.0.0 0.0.0.0 fastethernet 0/1

0 Helpful

Ngjohnquilla
Level 1
Level 1
In response to Georg Pauwen

‎12-29-2016 09:06 AM

I already remove all ip routes.. i still cant ping 10.1.10.1 from the command prompt of my laptop B

0 Helpful

chrihussey
VIP Alumni
VIP Alumni
In response to Ngjohnquilla

‎12-29-2016 08:55 AM

Not sure why you have the static routes configured on the router, you really don't need them.

Removed these:

no ip route 10.0.0.0 255.255.255.0 FastEthernet0/1
no ip route 10.1.10.0 255.255.255.0 FastEthernet0/1
no ip route 10.1.10.0 255.255.255.0 FastEthernet0/0
no ip route 10.1.20.0 255.255.255.0 FastEthernet0/1

also, fix your default route, it shouldn't point to the interface, it should point to the next hop IP

ip route 0.0.0.0 0.0.0.0 x.x.x.x

0 Helpful

Ngjohnquilla
Level 1
Level 1
In response to Ngjohnquilla

‎12-29-2016 08:48 AM

see attached file for my running-config on both devices

Preview file
7 KB
0 Helpful

Georg Pauwen
VIP
VIP
In response to Ngjohnquilla

‎12-29-2016 08:22 AM

Hello,

I labbed this in GNS3. Make sure that on your 3550, interfaces FastEthernet0/1 and FastEthernet0/3 are configured as access ports belonging to Vlan 10, and FastEthernet0/5 and FastEthernet0/9 as access ports belonging to Vlan 20:

interface FastEthernet0/1

switchport access vlan 10

interface FastEthernet0/3

switchport access vlan 10

interface FastEthernet0/5

switchport access vlan 20

interface FastEthernet0/9

switchport access vlan 20

0 Helpful

Ngjohnquilla
Level 1
Level 1
In response to Georg Pauwen

‎12-29-2016 08:39 AM

that exactly what i did..

here:

router configuration
Password:
noyrouter>enable
Password:
noyrouter#show ip int br
Interface IP-Address OK? Method Status Protocol
FastEthernet0/0 10.1.10.1 YES NVRAM up up
Serial0/0 unassigned YES NVRAM administratively down down
FastEthernet0/1 10.1.20.1 YES NVRAM up up
noyrouter#show interface fa 0/1
FastEthernet0/1 is up, line protocol is up
Hardware is AmdFE, address is 0009.b7f8.be61 (bia 0009.b7f8.be61)
Internet address is 10.1.20.1/24
MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 100Mb/s, 100BaseTX/FX
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:08, output 00:00:05, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
4 packets input, 984 bytes
Received 4 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog
0 input packets with dribble condition detected
15 packets output, 2128 bytes, 0 underruns
0 output errors, 0 collisions, 1 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out
noyrouter#show ip route
Codes: C - connected, S - static, R - RIP, M - mobile, B - BGP
D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area
N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
E1 - OSPF external type 1, E2 - OSPF external type 2
i - IS-IS, su - IS-IS summary, L1 - IS-IS level-1, L2 - IS-IS level-2
ia - IS-IS inter area, * - candidate default, U - per-user static route
o - ODR, P - periodic downloaded static route

Gateway of last resort is 0.0.0.0 to network 0.0.0.0

10.0.0.0/24 is subnetted, 3 subnets
C 10.1.10.0 is directly connected, FastEthernet0/0
S 10.0.0.0 is directly connected, FastEthernet0/1
C 10.1.20.0 is directly connected, FastEthernet0/1
S* 0.0.0.0/0 is directly connected, FastEthernet0/1
noyrouter#show interfa fa 0/0
FastEthernet0/0 is up, line protocol is up
Hardware is AmdFE, address is 0009.b7f8.be60 (bia 0009.b7f8.be60)
Internet address is 10.1.10.1/24
MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 100Mb/s, 100BaseTX/FX
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:45, output 00:00:01, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
1 packets input, 390 bytes
Received 1 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog
0 input packets with dribble condition detected
16 packets output, 2188 bytes, 0 underruns
0 output errors, 0 collisions, 2 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out
noyrouter#


*******************************************************************************************

switch Configuration
noyswitch con0 is now available

Press RETURN to get started.


violators will be persecuted

User Access Verification

Password:
noyswitch>enable
Password:
noyswitch#show ip int br
Interface IP-Address OK? Method Status Protocol
Vlan1 10.1.1.25 YES NVRAM up down
Vlan10 unassigned YES NVRAM up up
Vlan20 unassigned YES NVRAM up up
FastEthernet0/1 unassigned YES unset up up
FastEthernet0/2 unassigned YES unset administratively down down
FastEthernet0/3 unassigned YES unset down down
FastEthernet0/4 unassigned YES unset administratively down down
FastEthernet0/5 unassigned YES unset up up
FastEthernet0/6 unassigned YES unset administratively down down
FastEthernet0/7 unassigned YES unset administratively down down
FastEthernet0/8 unassigned YES unset administratively down down
FastEthernet0/9 unassigned YES unset up up
FastEthernet0/10 unassigned YES unset administratively down down
FastEthernet0/11 unassigned YES unset administratively down down
FastEthernet0/12 unassigned YES unset administratively down down
FastEthernet0/13 unassigned YES unset administratively down down
FastEthernet0/14 unassigned YES unset administratively down down
FastEthernet0/15 unassigned YES unset administratively down down
FastEthernet0/16 unassigned YES unset administratively down down
FastEthernet0/17 unassigned YES unset administratively down down
FastEthernet0/18 unassigned YES unset administratively down down
FastEthernet0/19 unassigned YES unset administratively down down
FastEthernet0/20 unassigned YES unset administratively down down
FastEthernet0/21 unassigned YES unset administratively down down
FastEthernet0/22 unassigned YES unset administratively down down
FastEthernet0/23 unassigned YES unset administratively down down
FastEthernet0/24 unassigned YES unset administratively down down
GigabitEthernet0/1 unassigned YES unset down down
GigabitEthernet0/2 unassigned YES unset down down
noyswitch#
noyswitch#show vlan br

VLAN Name Status Ports
---- -------------------------------- --------- -------------------------------
1 default active Fa0/2, Fa0/4, Fa0/6, Fa0/7
Fa0/8, Fa0/10, Fa0/11, Fa0/12
Fa0/13, Fa0/14, Fa0/15, Fa0/16
Fa0/17, Fa0/18, Fa0/19, Fa0/20
Fa0/21, Fa0/22, Fa0/23, Fa0/24
Gi0/1, Gi0/2
10 mypc active Fa0/1, Fa0/3
20 myroute active Fa0/5, Fa0/9
1002 fddi-default act/unsup
1003 token-ring-default act/unsup
1004 fddinet-default act/unsup
1005 trnet-default act/unsup
noyswitch#show cdp neighbors
Capability Codes: R - Router, T - Trans Bridge, B - Source Route Bridge
S - Switch, H - Host, I - IGMP, r - Repeater, P - Phone

Device ID Local Intrfce Holdtme Capability Platform Port ID
noyrouter Fas 0/5 159 R 2621 Fas 0/1
noyrouter Fas 0/1 159 R 2621 Fas 0/0
noyswitch#show ip defa
noyswitch#show ip default-gateway
0.0.0.0
noyswitch#

0 Helpful

devils_advocate
Level 7
Level 7

‎12-29-2016 06:25 AM

So you are trying to ping 10.1.10.1 using 10.1.20.1 as a source from the CLI of the router itself?

Can each host ping their default gateway?

Can each host ping each others default gateway?

Can you post the configs?

0 Helpful

Ngjohnquilla
Level 1
Level 1
In response to devils_advocate

‎12-29-2016 07:37 AM

I'm trying to ping the router 10.1.10.1 which is in interface fa0/0 using the command prompt. 

I can ping fa0/0 10.1.10.1 using laptop A because they have the same gateway but i cant ping fa0/1 10.1.20.1 of the router 

I can ping fa0/1 10.1.20.1 using laptop B with the same situation with laptop A, i cant ping fa0/0

What do you mean post the configs? Of the router?.. 

Thank you I appreciate your reply

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking for a $25 gift card