05-06-2007 10:52 PM - edited 03-05-2019 03:54 PM
Hi,
i get error message "ERROR: access-list has protocol or port" while adding a line nat (inside) 0 access-list zeronat0" can some one tell me what exactly the problem is.
Cisco ASA 5510 - asa704-k8.bin
05-06-2007 11:18 PM
Hi,
Have you checked the acl zeronat0...
-VJ
05-06-2007 11:22 PM
what exactly it mean? this message i get in my standby ASA, where as in my main ASA i never get this message when adding, also in main ASA, when i type "write standby" all lines gets synced,except the one which i was trying.
05-06-2007 11:21 PM
removing the redundant post.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide