Switching

Hi all,Is there any feature like "Web-Based Proxy Authentication" in catalyst 6500 run IOS?I saw that in Catalyst 6500 running CatOS but in IOS. Can anyone show me the similar feature in IOS.Thanks in advance,Phuong@

I have this PIX501 box and this is what I want to do: Outside: connect it to a DSL modem (yahoo/ATT SpeedStream 5100). Use DHCP Inside: connect to one or two PCs. Use static IP. The PIX box's inside IP: 192.168.1.1 The Yahoo's DNS server IP: 192.168....

I have 2 1900's f0/26 & f0/27 "suspended no link-beat" the led's don't come on, have entered trunk on. I get this if I'm connecting to the other 1900 or aui of a 2500

Is it possible for a Catalyst 6500 series switch to generate snmp traps upon the generation of interface errors (e.g. CRC, underrun)?

Hi,I am configuring a Layer 3 switch and the configuration will be similar to our Cat2948G. While setting up the access-lists I came across this statement.access-list 110 permit ip any any precedence criticalwhich goes with priority-list 1 protocol i...

Dear All,I have Cisco 1841 Router with e ports - fa0/0 and 0/1. 0/0 is configured for vlan trunking and 4 subnets are configured.default gateway for router is inside IP of Pix 506 e 6.3(4). The IP details are below.Fa0/0 - 192.168.165.910.1 - 192.168...

I need to know if the IOS Firewall processes traffic in hardware or software. I would like to take advantage of the feature, but don't want it to have an impact on performance. Oh, and right now we can't justify the $ for FWSM modules.Thanks.

Got a cisco 831 and I need to know if this router is capable of doing the pppoe auth without having the ATM interface. Currently my dsl modem is in bridge mode with a wrt54g doing the pppoe login/auth. TIA

I am running RIP and currently redistributing only the default route using the "default-info originate" command. This router also has two "types" static routes. I use static routes using the simple ip route command and I also have static routes tha...

We are trying to monitor all of our VOIP traffic and have been running into some issues so I'm in need of some help. In our current environment, we have a whole bunch of Cisco IP phones that are connected to both Cisco 3560, and 2950 switches. The ...

Hello everyone,Well I am back, I was able to flash the IOS and I am able to access configuration. Now the issue is that I am trying to access the GUI, so I can configure the settings. The IP address the IPSU (thank you cisco) gives me the ip addres...

I've done a bit of reading about PoE for the 2626-PWR however I'd like a confirmation on a few bits...1. Does the ProCurve 2626-PWR Supply Power for PoE to the Cisco Devices or would I have to use the Cisco PoE Injector module one for each Cisco AP1...

I hope I do not sound like an idiot but to date I have never had to upgrade the firmware on our Catalyst switches. So now I am at the point to where I want to but it seems as if either some of the switches have no upgrades and I also want to be sure ...

Hi all, people at my work are saying the internet is going down at midnight, is there any software where i can monitor the connection to the internet ?