05-27-2024 02:10 AM
I was given an assignment to draw a schematic of an enterprise LAN in cisco packet tracer.
I configured 1 server for dhcp 2 server for backup dhcp and dns
When I connect computers on the 1st floor from the 1st switchboard, it receives dhcp.
but I need to make it so that ip phone was connected to 1 floor switch and through ip phone it was connected to computer on 1 floor and that this computer received dhcp and at the same time it is necessary to give static ip address to ip phone and give it a number
How do I configure all this so that I can give ip addresses and numbers to the phone?
It is not possible to give number and ip address in the ip phone itself through setting
05-27-2024 02:51 AM
Здравствуйте, можешь ли ты опубликовать заархивированный файл проекта Packet Tracer (.pkt)?
05-27-2024 03:06 AM
05-28-2024 01:44 AM - edited 05-28-2024 01:45 AM
Hello
Basic example:
Attach:
pc to voip
voip to switch
rtr to switch
RTR
will need a dhcp scope for the data vlan and option 150 applied for voip phone to communicate and receive its dn registration, additionally telephony needs to be created
Switch
The switch ports need to be an administrative mode of access and assigned a voice vlan ( vlan1 can be used for testing) need to support POE.
05-28-2024 02:42 AM
everything works, but is it possible to make it so that I myself can prescribe static ip address to phones and number too
example ip phone 192.168.10.1 (static)
pc 192.168.1.50 (dhcp)
05-27-2024 05:01 AM
еще какая то информация нужна? просто я в тупике уже не знаю что делать
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide