IE 2000U Express Setup issue - no login screen

[camuschinski]

I have the instructions, but switch login screen doesn't come up. I have it connected to my laptop thru a USB/ENET adapter. I tried it both with that laptop port set to a static IP and subnet mask, and also with the port set to automatically assign IP. But same results. When I launch browser, I just get my home page, no Cisco login screen. Reset the switch a few times and retried. No luck. I'm running Win7 Pro with IE11 browser. Can anyone let me know what my network setting should be for the laptop port? Also........... the setup manual refers to "Setup" LED, but the IE2000 U has no LED labeled "Setup". "USB", "EXP", and "SYS".  Thanks!

[Georg Pauwen]

I am not sure your flash is working correctly. It seems to be initializing, but you might want to check it for consistency:

switch: fsck -test flash:

[camuschinski]

I tried that command you suggest. See attachment. I am now going to try to install a new iOS on the switch. I downloaded it from Cisco.

[Georg Pauwen]

Hello,

that of course is the last option, but your flash could be faulty. Where did you get that device from ?

[camuschinski]

I tried to install a new iOS in the switch. Got the file from Cisco site. It only wanted to run at 9600 baud. This took 6+ hours! I used Tera Term. It displayed the % Complete and Time into the process throughout. Right at the end it says "I/O error". I try to boot from flash ....... no good. See the first screenshot in the attachment.

I used the .bin file. I also downloaded the .tar file (which is larger and will take longer if I try to copy it over). I'm debating whether to try the .tar file or look elsewhere for a solution.

Thoughts?

[camuschinski]

I forgot the attachment. Here it is.

[Georg Pauwen]

Hello,

just to make sure your reset to factory defaults went ok, did you also do step 2 ?

To reset the switch:

Step 1 Press and hold the Express Setup button for 10 seconds or more. The switch reboots. The system LED turns green after the switch completes rebooting.

Step 2 Press the Express Setup button again for 3 seconds. A switch 10/100 Ethernet port blinks green.

[BO.ZHU]

i had the same problems,but i fixed it although without  pop-up to log in....

1...push that button "express setup" for 3 seconds ,

2..port 1 will blink green

3...insert cable to port1,

4..open net work and  share center to check the ip adress you auto get..and you also will find DHCP

   SERVER IP''192.168.1.254'

5,,,Open your IE Insert this ip 192.168.1.254

6..the log in window will appear...

-------------

after i setup,i assigned a  static ip to switch,but i can't connect it use it..and i try to reset to factory,it also didn't work