If I remove a stack member, will the config remain?

[Translator]

Hi~ All

Some documents say that only Active-standby has a copy of the config.

Meanwhile, other documents state that all members have a config.
https://community.cisco.com/t5/switching/what-happens-to-a-switch-s-config-when-it-is-removed-from-a/td-p/4469423

When removing a stack member, will the config remain if I connect to the member? Will it disappear? Which one is correct?

[Translator]

Hi~ All

Some documents say that only Active-standby has a copy of the config.

Meanwhile, other documents state that all members have a config.
https://community.cisco.com/t5/switching/what-happens-to-a-switch-s-config-when-it-is-removed-from-a/td-p/4469423

When removing a stack member, will the config remain if I connect to the member? Will it disappear? Which one is correct?

[DanielP211 · Accepted solution]

Hello!

Yes the configuration will remain and you will be able to replace the disconnected member. Each of the members has the configuration.

BR

[Translator]

@DanielP211 

Thank you for your response!

So it's not just active-standby that has the configuration?

So if I remove the member and reboot, will the configuration still be there?