HI,
I have a problem with a switch Cisco 2960X, It there's an error in the log on an interface, what bothers me and I do not have any device to connect it.
Here is the run sho interface and the log message :
My software version is : 15.2(2)E4
Oct 4 22:30:51: %ILPOWER-7-DETECT: Interface Gi1/0/11: Power Device detected: IEEE PD
Oct 4 22:31:21: %ILPOWER-3-CONTROLLER_PORT_ERR: Controller port error, Interface Gi1/0/11: Power given, but Power Controller does not report Power Good
interface GigabitEthernet1/0/11
switchport
switchport access vlan 11
switchport private-vlan trunk encapsulation dot1q
switchport private-vlan trunk native vlan tag
switchport mode access
switchport nonegotiate
no switchport protected
no switchport block multicast
no switchport block unicast
switchport port-security maximum 65535 vlan voice
no switchport port-security mac-address sticky
no ip arp inspection trust
ip arp inspection limit rate 15 burst interval 1
ip arp inspection limit rate 15
no logging event link-status
load-interval 300
carrier-delay 2
no shutdown
tx-ring-limit 0
tx-queue-limit 0
power inline auto max 30000
power inline static
power inline never
power inline police
ipv6 mld snooping tcn flood
snmp trap mac-notification change added
snmp trap mac-notification change removed
no snmp trap link-status
mls qos cos 0
no cdp enable
arp arpa
arp timeout 14400
spanning-tree portfast disable
spanning-tree portfast trunk
spanning-tree portfast
spanning-tree bpduguard enable
spanning-tree port-priority 128
spanning-tree cost 0
hold-queue 75 in
hold-queue 40 out
ip igmp snooping tcn flood
Thank you for your HEL
