Initial boot "System received a System Error"

[pelston3233]

Hello all,

I need help trying to manually intervene and stop a newly purchased used Cisco 2811 router that loops and keeps trying to upgrade the ROMMON and self decompress the image? Here's the message:

Writing crashinfo to flash:crashinfo_20170418-014517-UTC
m
*** System received a System Error ***
signal= 0x16, code= 0x0, context= 0x49691318
PC = 0x4007de54, Cause = 0x2020, Status Reg = 0x34008002

System Bootstrap, Version 12.4(13r)T, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 2006 by cisco Systems, Inc.

Initializing memory for ECC
.
c2811 platform with 262144 Kbytes of main memory
Main memory is configured to 64 bit mode with ECC enabled

Upgrade ROMMON initialized
program load complete, entry point: 0x8000f000, size: 0xcb80
program load complete, entry point: 0x8000f000, size: 0xcb80

[Leo Laohoo]

If the router has NM/NME &/or WIC/HWIC cards, pull them all out. 

Console into the router and reboot the router, we want to see everything (and don't edit things out, IP addresses excluded).